A delivery from Enhance Performance arrived this morning, so got it fitted and went a spin! Polished intake pipe. I'll do a short write up of the fitting (really straight forward)
So to fit it, first remove the MAF sensor. Pull back the clip on the side and it'll pull off. Detach the hose clipped into the side, this just pulls off.
There's two jubilee clips needing undone on the original black hose. One on the bottom where it connects to the pipe and one at the top, below the MAF. You can see them in this picture.
Once these clips are unscrewed, remove them and take the black hose off.
Original vs new
In the package I received, I had the new pipe, two silicone joining sections and 4 x new jubilee clips (2x 60-80mm and 2x 70-90mm)
Use the larger, angled silicone section on the bottom along with one of each sized clip. The 60-80mm fits around the bottom and the 70-90mm on the top.
Repeat this for the section to join the cone filter/air box. Smaller clip on top and the larger on the bottom and reattach the MAF once its all tightened up.
I had originally fitted both of my larger clips to the angled section at the bottom of the pipe and found one of the 60-80mm clips wouldn't fit around the wider part.
Here's it fitted!
Here's a couple of videos.. I hadn't noticed the exhaust crackling and banging so much before but that's maybe because it was cold.
Sent from my E6853 using Tapatalk